【 Properties】
|
Silicone resin are mixtures
of solvent (toluene or xylene) with combined hydrolyzates of methyl
chlorosilanes and phenyl chlorosilanes contain some amount of hydroxyl
groups. The hydroxyl can further condensed into a hard film under
heating. Solid content is 50~70% on sale.
Outstanding insulation property, high-and-low-temperature
resistance, corona and electric arc resistance,
water-proof.
Outstanding resistance to weather-aging, ozone and chemicals.
With silicone resin, the H-grade motor, other electric appliances would be
size-small, weight-light, last-long and could be used under harsh
environment.
When over loaded, the motor or other electric appliance would not go out of
order and would not burn heavily. The gasses giving off are not poisonous.
The remains after burning is silicon dioxide.
|
【Specifications】
|
Appearance
|
Light-yellow to red-brown
transparent liquid
|
Solid content (180oC,24hr.)
|
Min. 50%
|
Viscosity (25oC)
|
25~75 mm2/s
|
Drying time (200oC,
on copper sheet)
|
Max. 1.5 hr.
|
Heat resistance (200oC, on
copper sheet)
|
Min. 200 hr.
|
Weight lost (250oC,3hr.)
|
Max. 5%
|
Puncture voltage (MV/m)
|
15oC~25oC
|
Min. 65 mv/m
|
200oC
|
Min. 25 mv/m
|
Volume resistance
coefficient
|
normal state, 15oC~25oC
|
Min. 1013 Omega cm
|
high temp. 200oC
|
Min. 1011 Omega cm
|
95%moisture, 4hr, 15oC~25oC
|
Min. 1012 Omega cm
|
Storage time
|
Min. 12 months
|
|
【 How to use】
|
-
Dilute with toluene,
xylene or solvent-petrol;
-
Dip, spray or brush
onto work-pieces;
-
Preheated at 110~140oC
first for extracting solvents, then heated at 160~180oC, at
last heated at 200oC;
-
Catalyst can be added
to accelerate the process, mall amount of catalyst such as
naphthalene acid will improve the process a lot. Zinc-,lead-,
manganese-, cobalt-carboxylate and amine could be used also;
-
The amount of added
catalyst is decided by experience. To avoid gelating, the resin added
catalyst must be used up as soon as possible.
-
The silicone resin
containing some amount of aluminum powder can be used at temperature as
high as 300oC,even higher.
Cautions:
1. Diluent must not contain water, sulfur-containing organic stuff,
pyridine and other impurities. Otherwise the adhesion would be lower, the
coating film would be viscid.
2. As large amount of solvent (as toluene, etc.) will give off in the
processing, workshop must be well ventilated, keep away from fire. Also,
labor protection is essential.
3. Impurities, dirty powders, etc., could damage the insulating property,
so the shops, equipment and tools must keep clean in the processing.
4. Acid, alkali, carboxylate
and amine quickening the cure process, lowing down the resistance to the
high-temperature and damaging the insulation properties, the resins must be
isolated from the above stuffs.
|
【 Packing, Storage and
Transportation】
|
-
Packing: 25KG,100KG net
in iron drum.
-
Storage: Keep away from
sun, acid, alkali, fire and heat source. Keep in dry, cold and well
ventilated place.
-
Transportation: As
inflammable chemicals.
|